What are you working on now?

[bmsm]

Sent from my iPhone using Tapatalk

[wwwEvgeny]

time for diving after a long pause

Sent from my SM-S9380 using Tapatalk

[bmsm]

Done.

All by hand, from cutting the steel, shape it and polishing.

Video here:
https://www.instagram.com/s/aGlnaGxpZ2h ... 6YWRwMA==


Sent from my iPhone using Tapatalk

[dj57]

There is always an issue when using an ETA/UNITAS movement with their bold screws.
You can‘t have both, fixing the movement and screwing the caseback. Right?



On the other hand side you can’t use the AliE etc screws because these are thin and short.
Solution:

Mark the area which has to be reduced. Then put it in a pin vice or so and file the marked area as far as you need.




Same solution used Molnija for their wristwatches with their 3602/3 movements.

[bmsm]

Sent from my iPhone using Tapatalk

[wwwEvgeny]

Done.

All by hand, from cutting the steel, shape it and polishing.

Video here:
https://www.instagram.com/s/aGlnaGxpZ2h ... 6YWRwMA==


Sent from my iPhone using Tapatalk

thank you for sharing! very nice job. need patience and detailed work. it's like cultivating the grape and get the wine later, process )) takes time
.

[wwwEvgeny]

There is always an issue when using an ETA/UNITAS movement with their bold screws.
You can‘t have both, fixing the movement and screwing the caseback. Right?



On the other hand side you can’t use the AliE etc screws because these are thin and short.
Solution:

Same solution used Molnija for their wristwatches with their 3602/3 movements.

Clean job! very nice!
.

[bmsm]

Sent from my iPhone using Tapatalk

[wwwEvgeny]

3 weeks before trip to Italy but I started crazy mods on the movement, hopefully can take it with me ticking

Sent from my SM-S9380 using Tapatalk

[dj57]

OMEGA mariage watches

1.) 46mm case
Here the dial had to be recused very little



2.) 44mm case
Here the dial had to be reduced ~2mm