Homage Forum

Ncrich wrote: ↑January 25th, 2021, 12:28 pm

Special one, nice!

Yoda wrote: ↑January 25th, 2021, 1:17 pm

Ncrich wrote: ↑January 25th, 2021, 12:28 pm

Special one, nice!

Ncrich wrote:

What a beauty

Sent from my SM-M205F using Tapatalk

I think I'll just do the rose gold case.



Black hands? Or rose gold hands?

tafari wrote:

Erick510 wrote:It's going to be a long journey I need polished angelus hands

Sent from my SM-N986U using Tapatalk

great movement, looking ahead for a great build. I use to polish my hands by hand, get a very good result.

You have a PM coming I have questions

Sent from my SM-N986U using Tapatalk

Ncrich wrote:I think I'll just do the rose gold case.



Black hands? Or rose gold hands?

Black hands look good I think

Sent from my SM-N986U using Tapatalk

Erick510 wrote: ↑January 25th, 2021, 2:30 pm

Ncrich wrote:I think I'll just do the rose gold case.



Black hands? Or rose gold hands?

Black hands look good I think

Sent from my SM-N986U using Tapatalk

Ncrich wrote:

Erick510 wrote: ↑January 25th, 2021, 2:30 pm

Ncrich wrote:I think I'll just do the rose gold case.



Black hands? Or rose gold hands?

Black hands look good I think

Sent from my SM-N986U using Tapatalk

Here's a close up

Sent from my SM-N986U using Tapatalk

I thought this would be easy. Custom reamers/broaches to fit into my Seitz tool. On the right you can see two factory reamers from Seitz for jeweling. On the left four reamers I made to do 616 and 6497 watch hands.

The shank has a taper that needs to match the holding tool. The reamer has a 3 degree taper and then it has a relief on the cutting edge that runs parallel to the cutting edge (with the 3 degree taper). I felt like Clickspring making these. Will harden and temper them this evening. Give them a final polish and should be good to go.

9401/1 M.N.


Sent from my iPhone using Tapatalk