Homage Forum

You did a fabulous job with the dials!!!

Friends, I decided to treat myself to new tweezers in NY.
I reduced the choice to Bergeon and Dumont. In my research, I found out some information that may be useful to someone

Screwed and welded NW tube in an Alli case.





The plexy was cracked, perhaps due to the pressure I applied with my hand when grabbing it to make the thread.

How about an idea like this?
Pocket watch was with an ETA/Unitas movement. Therefore no issues to build a PAM homage pocket watch.

dj57 wrote: ↑December 9th, 2023, 3:54 pm How about an idea like this?
Pocket watch was with an ETA/Unitas movement. Therefore no issues to build a PAM homage pocket watch.

Super
Close enough to PAM00447

dj57 wrote: ↑December 9th, 2023, 3:54 pm How about an idea like this?
Pocket watch was with an ETA/Unitas movement. Therefore no issues to build a PAM homage pocket watch.

Nice!
What about using a sober/smooth pocket case, without lid, and solder wire lugs? trench watch style....

Belkin12 wrote:

dj57 wrote: ↑December 9th, 2023, 3:54 pm How about an idea like this?
Pocket watch was with an ETA/Unitas movement. Therefore no issues to build a PAM homage pocket watch.

Super
Close enough to PAM00447

Thanks D.
I think this pocket watch case is closer to the PAM00447.

Fizzzz wrote:

dj57 wrote: ↑December 9th, 2023, 3:54 pm How about an idea like this?
Pocket watch was with an ETA/Unitas movement. Therefore no issues to build a PAM homage pocket watch.

Nice!
What about using a sober/smooth pocket case, without lid, and solder wire lugs? trench watch style....

Regarding pocket case, see above answer with pic to Belkin12.

It’s only a request of a friend of mine. He just wants a PAM style pocket watch.
I‘ve built a Flieger style pocket watch for him either.

I didn't knew PAM00447
It seems like we were on the same idea

Now without lid.