What are you working on now?

[wwwEvgeny]

20231213_155626-01.jpeg

Very nice! How are you going to solder the tube?

[NortON]

20231213_155626-01.jpeg

Very nice! How are you going to solder the tube?

Thx E! I didn't solder the tube, I glued it

[NortON]

20231216_101941-01.jpeg

20231216_101952-01.jpeg

[Woundup]

Very nice work! What are the details on the crown? Athaya?

[NortON]

Very nice work! What are the details on the crown? Athaya?

Thx! Yes, Athaya crown, NW Plexi and lug bars, CB from AliNW 6152

[Nottingham]

Just finished, Quick plug and play! Ali case, river dial plainted and lumed by me, NW crown and tube, random hands aged and seagull st36! What else?!

[dj57]

Just finished, Quick plug and play! Ali case, river dial plainted and lumed by me, NW crown and tube, random hands aged and seagull st36! What else?!

Very nice.
Since you asked… how about the strap.

[Nottingham]

Just finished, Quick plug and play! Ali case, river dial plainted and lumed by me, NW crown and tube, random hands aged and seagull st36! What else?!

Very nice.
Since you asked… how about the strap.

Hé, thanks, the strap is made by me with an old military leather and sewn in gpf handmade buckle, vintage three plies garanteed!

[Woundup]

I bought a little table top drill press from Amazon, so I've been working on refining my technique on enlarging the Ali X 6154 case lug holes to 2mm. Also through several attempts I managed to figure out how to nicely finish the ends of the 2mm steel rod that I cut to size. I'm making these so that they fit firmly in place without requiring compression tubes but also tap out reasonable easily.

Spent some time today on case work as well - nothing drastic just some edge softening.

[earloflondon]

Cool

Sent from my SM-M205F using Tapatalk