Page 790 of 2720
Re: The perpetual wrist shot thread
Posted: August 20th, 2020, 1:22 am
by Xbuddy313
Third and hopefully final rebuild on DSN slob. This time with an eta from unreformed66. Third times the charm!
Sent from my iPad using Tapatalk
Re: The perpetual wrist shot thread
Posted: August 20th, 2020, 2:32 am
by Madantique
wwwEvgeny wrote: ↑August 19th, 2020, 6:16 am
Love this dial! is it custom made or serial made?
Custom from some information on Panerai.
https://www.facebook.com/media/set?vani ... 7217824106
Re: The perpetual wrist shot thread
Posted: August 20th, 2020, 3:28 am
by Simonix
Re: The perpetual wrist shot thread
Posted: August 20th, 2020, 5:09 am
by Alhig72
Sent from my LYA-L09 using Tapatalk
Re: The perpetual wrist shot thread
Posted: August 20th, 2020, 5:15 am
by NortON
Simonix wrote:
Nice one!
Отправлено с моего SM-G970F через Tapatalk
Re: The perpetual wrist shot thread
Posted: August 20th, 2020, 8:07 am
by Madantique
Re: The perpetual wrist shot thread
Posted: August 20th, 2020, 10:01 am
by Mir36
Xbuddy313 wrote: ↑August 20th, 2020, 1:22 am
Third and hopefully final rebuild on DSN slob. This time with an eta from unreformed66. Third times the charm!
Sent from my iPad using Tapatalk
Nice slob! Is the brass showing basically the brass dial plate behind the dial? I assume the dial diameter is smaller than normal? This project had long eluded me.
Re: The perpetual wrist shot thread
Posted: August 20th, 2020, 10:04 am
by Mir36
Re: The perpetual wrist shot thread
Posted: August 20th, 2020, 12:19 pm
by Xbuddy313
@mir36, hard to explain, the brass is flush and the dial is built within it. Dsn did a great job.
Re: The perpetual wrist shot thread
Posted: August 20th, 2020, 2:26 pm
by Mellons
Mir36 wrote: ↑August 20th, 2020, 10:01 am
Xbuddy313 wrote: ↑August 20th, 2020, 1:22 am
Third and hopefully final rebuild on DSN slob. This time with an eta from unreformed66. Third times the charm!
Sent from my iPad using Tapatalk
Nice slob! Is the brass showing basically the brass dial plate behind the dial? I assume the dial diameter is smaller than normal? This project had long eluded me.
Image reminds me i never built
Or obtained a slob- must!
