Homage Forum

I'm sure few of you guys have seen this ... I received a dial recently day. It came in this very very cool container where the dial was suspended inside! Neither the face, nor the back was touching, or rattling ... there is a rubber tip that inserts into the center hole and held the dial floating!!!

I did some research and on the Omegaforum ... the guys there did a mass order from the company, probably a couple of euros each.

So for anyone that keeps or stores dials ....

http://www.schallersa.ch/products/plast ... parts.html

....
....
.....

..... the usual ways too store dials .... not so good ....

very cool

I keep mine in a container, keeping the surface away from everything. It's nifty though.

I can 3D print this...

Yes?!

Emilio wrote: ↑May 15th, 2019, 12:31 pm I can 3D print this...

That would be great!

Saw these on the Bay.
https://www.ebay.com/itm/Dial-case-for- ... Sw97hcS1at

nice, i have to go back and check the status of my dials..............

Yes ... I have a few dials and worry about their storage

leeyewfei wrote: ↑May 15th, 2019, 8:46 pm nice, i have to go back and check the status of my dials..............

Thanks ... how did I miss those on Ebay!? ... his price is Ok ... taking into account that the guys over on Omegaforum purchased large quantity and then sold them for 2.50+ euro?

Mike777 wrote: ↑May 15th, 2019, 8:30 pm Saw these on the Bay.
https://www.ebay.com/itm/Dial-case-for- ... Sw97hcS1at