Page 1 of 1
7s26?
Posted: January 18th, 2021, 8:08 am
by Icemanxxxv
Are all the dials the same size? I have a 7s26-0060 looking to change it up with a dial and hand swap.
Thanx!
Re: 7s26?
Posted: January 18th, 2021, 9:02 am
by Simonix
Hello and welcome to the forum!
Re: 7s26?
Posted: January 18th, 2021, 9:14 am
by Yoda
Icemanxxxv wrote: ↑January 18th, 2021, 8:08 am
Are all the dials the same size? I have a 7s26-0060 looking to change it up with a dial and hand swap.
Thanx!
As far as I know, yes.
Re: 7s26?
Posted: January 18th, 2021, 3:08 pm
by Mellons
Welcome!
Re: 7s26?
Posted: January 18th, 2021, 6:35 pm
by burauzaa
Just make sure it has the right crown orientation for your case. Usually dials will say for 3 or 4 o'clock crown. The dial feet are positioned accordingly.
Re: 7s26?
Posted: February 1st, 2021, 9:55 am
by Protimoi07
7S26 dial size is 28.5mm diameter typically. And yes be sure the dial states which crown orientation it has - for 3 or 4 o clock typically on 7S26. If the dial orientation is wrong, you can always snip the dots off and use replacement dial dots for the correct orientation. Good luck!
Re: 7s26?
Posted: February 1st, 2021, 12:28 pm
by big eebee
Aftermarket dials usually come with 2 sets of feet, you snip the ones you don't want