Page 1 of 1
Prototype 6152/1 plexi bezel
Posted: May 29th, 2025, 4:31 am
by Rainy (Bonny B)
Finally my prototype 6152-1 is done. Just a few details to catch up. I did used Ali express 6152-1 for the reference size . On 12 will be 3mm. Clear acrylic with white lume 1/2/4/5/7/8/10/11 will be black 2 mm. And on the side 4/8/12 will be 2mm. Clear acrylic. I did this plexi bezel from the photo and some Nickyzips old post reference. So I can't do the click on the bezel like Gen or Nickyzips because, can't find the photo reference or any detail. What I did is make the plexi bezel quite tide so when it sit on the bezel it will be secured not move and when you want to take it out just used the screw driver to push it out quite easy. All 12 dot i did it on Lathe machine each by each it very hard because ,is so small and delicate. Hope everyone enjoy my plexi bezel project.
Re: Prototype 6152/1 plexi bezel
Posted: May 29th, 2025, 6:07 am
by Edam_
Wow!!!!
Re: Prototype 6152/1 plexi bezel
Posted: May 29th, 2025, 6:12 am
by NortON
Re: Prototype 6152/1 plexi bezel
Posted: May 29th, 2025, 6:40 am
by Rainy (Bonny B)
Edam_ wrote: ↑May 29th, 2025, 6:07 amWow!!!!
Thanks
Re: Prototype 6152/1 plexi bezel
Posted: May 29th, 2025, 6:44 am
by Rainy (Bonny B)
Re: Prototype 6152/1 plexi bezel
Posted: May 29th, 2025, 11:49 am
by wwwEvgeny
thank you for sharing your plexy project ! Looking forward for complete assembling. Especially like the picture with a small component inside the headstock of a large lathe . bravo!
Sent from my SM-S9380 using Tapatalk
Re: Prototype 6152/1 plexi bezel
Posted: May 29th, 2025, 3:42 pm
by Mellons
Excellent work, very tricky to get this right.
Re: Prototype 6152/1 plexi bezel
Posted: May 30th, 2025, 3:34 am
by Nottingham
How gorgeous project!
Re: Prototype 6152/1 plexi bezel
Posted: May 30th, 2025, 7:45 am
by tafari
looks very great
