What are you working on now?

[Tanukjaju]

[mention]leeyewfei[/mention] - thanks

Some people... I’m not naming names (cough [mention]Emilio[/mention] cough) don’t seem to sleep.

[Emilio]

[mention]leeyewfei[/mention] - thanks

Some people... I’m not naming names (cough [mention]Emilio[/mention] cough) don’t seem to sleep.

Sleeping is for the wicked!

[tafari]

more pics of the watch with the Instrument/Gauge Dial please

47mm egi case, Ross dial and hour hand, Molnija 3602, I tried to make some tall tube hands using some brass tubes I bought from eBay but it didn’t quite go to plan so I threw it in a drawer that must’ve been 4 years ago, then work just took over (I run my own business) and I forgot all about it same as all the others... now I’m determined to finish them all... wish me luck

beautiful watch


Gesendet von iPad mit Tapatalk

[tafari]

Welcome back to More madness [mention]Pickledbeetroot[/mention]

Today’s project

wow good job, looks amazing

[bmsm]

Had an issue, 2mm dial, 6497 movement and a blue 3646 hands for a Cort 616.

Start thinking about the issue and here’s the result:



Tall hour wheel from a 6497 that takes a 616 hands.

Next cannon pinion.

[spade_lt]

Had an issue, 2mm dial, 6497 movement and a blue 3646 hands for a Cort 616.

Start thinking about the issue and here’s the result:



Tall hour wheel from a 6497 that takes a 616 hands.

Next cannon pinion.

Impressive!

How did you make it?

[bmsm]

Had an issue, 2mm dial, 6497 movement and a blue 3646 hands for a Cort 616.

Start thinking about the issue and here’s the result:



Tall hour wheel from a 6497 that takes a 616 hands.

Next cannon pinion.

Impressive!

How did you make it?

From the old pocket watch cases I’ve around the place, those with lid I removed the tube that opens case front lid.




By hand I’ve used a file to adjust the tube length. After achieving the size I trimmed by hand one side from the outside and broached the opposite side.

I was measuring with an original 616 hands and a spare H2 hour wheel.

Attached the tube to the wheel using press fit. I was reading around the forum about attaching tubes to the hands, and notice that people talked about pressure fit. So applied the same. To attached and ensure it is straight, I used a spring bar that as the size I need, again a broken part that was lost in the drawer. Just need to broach the blue hands a little bit.

The problem is the cannon pinion. Not sure own to pull that one, but I’m thinking on it.

[tafari]

cleaning screws after polishing

[VanSong]

[mention]leeyewfei[/mention] - thanks

Some people... I’m not naming names (cough [mention]Emilio[/mention] cough) don’t seem to sleep.

Sleeping is for the wicked!

E, this is looking good! Don't forget more wrist shots.

Sent from my SM-N960F using Tapatalk

[Emilio]

[mention]leeyewfei[/mention] - thanks

Some people... I’m not naming names (cough [mention]Emilio[/mention] cough) don’t seem to sleep.

Sleeping is for the wicked!

E, this is looking good! Don't forget more wrist shots.

Sent from my SM-N960F using Tapatalk

Sure! The strap is the only one I have left (I will get a new one in the future). It's a mix of green, blue and brown.